Setting Surface Controls - IKEA FORSHALLAN Manual

SETTING SURFACE CONTROLS

Locations of the Gas Surface Burners
1. The SIMMER burner is best used for simmering
delicate sauces, etc.
2. The STANDARD sized burners are used for most
surface cooking needs.
3. The POWER burner is best used for bringing
large quantities of liquid rapidly up to tempera-
ture or when preparing larger quantities of food.
2
2
Figure 5: 30" Cooktop
2
2
Figure 6: 36" Cooktop
12
1
3
2
1
3
2
Setting a surface burner:
1. Place cooking utensil on center of surface burner
grate. Be sure the cooking utensil rests stable on
the burner grate.
2. Push the burner's surface control knob in and
turn counterclockwise out of the OFF position
(Figure 7).
3. Release the surface control knob and rotate to
the LITE position ( ). Visually check that the-
burner has a steady gas flame.
Once the surface burner has a flame, push the sur-
face control knob in and turn counterclockwise to
the desired flame size setting. Adjust the flame as
needed using the knob markings.
Figure 7: Surface control knob
NOTE
• When setting a surface control knob to the lite
position, all of the electronic surface ignitors
will spark at the same time. However, only the
surface burner you are setting will ignite.
• In the event of an electrical power outage, the
surface burners may be lit manually. To light
a surface burner, hold a lit match to the burn-
er head, then slowly turn the surface control
knob to lite. Once the burner ignites, push in
and turn knob out of lite then to the desired
flame setting. Use caution when lighting sur-
face burners manually.
en