Cisco 3100 Series Hardware Installation Manual page 34

Supported SFP/SFP+/QSFP+ Transceivers
Warning
Use appropriate ESD procedures when inserting the transceiver. Avoid touching the contacts at the rear, and
keep the contacts and ports free of dust and dirt. Keep unused transceivers in the ESD packing that they were
shipped in.
Caution Although non-Cisco SFPs are allowed, we do not recommend using them because they have not been tested
and validated by Cisco. Cisco TAC may refuse support for any interoperability problems that result from
using an untested third-party SFP transceiver.
The following table lists the supported transceivers for the fixed ports on all 3100 models, and the
FPR3K-XNM-8X10G and FPR3K-XNM-8X25G network modules.
Table 4: Supported 1-Gb SFP Transceivers
Optics Type
1G, 1000Base-T
1G multimode
1G single mode
1G SM extended r.
1G SM
The following table lists the supported transceivers for the fixed ports on all 3100 models and the
FPR3K-XNM-8X10G and FPR3K-XNM-8X25G network modules.
Table 5: Supported 10-Gb SFP Transceivers
Optics Type
10G-SR
10G-SR
10G-LR
10G-LR
10G-ER
10G-ZR
10G-ZR
Cisco Secure Firewall 3100 Series Hardware Installation Guide
30
PID
GLC-TE
GLC-SX-MMD
GLC-LH-SMD
GLC-EX-SMD
GLC-ZX-SMD
PID
SFP-10G-SR
SFP-10G-SR-S
SFP-10G-LR
SFP-10G-LR-S
SFP-10G-ER-S
SFP-10G-ZR
SFP-10G-ZR-S
Overview
Comments
1 Gb-copper SFP
850 nm
1310 nm
40 km
80 km
Comments
—
Ethernet only
—
Ethernet only
—
—
—