Canon imageFORMULA DR-M1060II User Manual page 30

Hint
• When [Rapid recovery system] is enabled in the [Others] tab of the
scanner driver settings screen, the following screen appears
instead of the above message screen. In such cases, place the
document again, and then click [Yes] to resume scanning.
• When sensors at both sides of the feed inlet detect the bent corner
of a stapled document, an error message appears and feeding
stops.
Staple detection may not operate properly in the following cases
where bending does not occur in documents.
– The document is stapled at two or more corners.
– The document is size smaller than STMT/A5.
30