Storing Your Own Sound Adjustments - JVC KD-S717 Instructions Manual

• When "SCM LINK" is set to "LINK ON", the
selected sound mode can be stored in memory
for the current source and the effect applies
only to the current source. Each time you
change the playback source, the SCM indicator
flashes on the display.
• When "SCM LINK" is set to "LINK OFF", the
selected sound mode effect applies to any
source.
Indication For:
BEAT Rock or disco
music
SOFT Quiet
background
music
POP Light music
SCM OFF (Flat sound)
Recalling the sound modes
When "SCM LINK" is set to "LINK ON,"
Select the source.
The sound mode stored in memory for the
selected source is recalled.
Notes:
• You can adjust each sound mode to your preference,
and store it in memory.
If you want to adjust and store your original sound
mode, see "Storing your own sound adjustments"
on the right column.
• To adjust the bass and treble reinforcement levels or
to turn on/off the loudness function temporarily, see
page 12. (Your adjustments will be canceled if
another source is selected.)
Preset values
BAS TRE LOUD
+02 00 ON
+01 –03 OFF
+04 +01 OFF
00 00 ON
Storing your own sound
adjustments
You can adjust the sound modes (BEAT, SOFT,
POP) to your preference and store your own
adjustments in memory.
• There is a time limit in doing the following
procedure. If the setting is canceled before you
finish, start from step 1 again.
1
Call up the sound mode you want to
adjust.
• See the left column for details.
2
Select "BAS (Bass)," "TRE (Treble)"
or "LOUD (Loudness)."
3
Adjust the bass or treble level or
turn the loudness function ON/OFF.
• See page 12 for details.
4
Repeat steps 2 and 3 to adjust the
other items.
5
Press and hold SCM until the sound
mode you have selected in step 1
flashes on the display.
Your adjustment made for the selected
sound mode is stored in memory.
6
Repeat the same procedure to store
other sound modes.
To reset to the factory settings
Repeat the same procedure and reassign the preset
values listed in the table on the left column.
13