Er1: Typically indicates damage to the formaldehyde sensor,
ambient temperature sensor or RH sensor.
Er2: Typically displayed for 1 second on the lower readout
when the meter tries to measure a temperature or RH
value outside the specified measurement range. It may
also be produced by clearing the Max/Min memory.
WARRANTY INFORMATION
This product from General Tools & Instruments (General) is
warranted to the original purchaser to be free from defects in
material and workmanship for a period of two years. Subject
to certain restrictions, General will repair or replace this
instrument if, after examination, the company determines it to
be defective in material or workmanship.
This warranty does not apply to damages that General
determines to be from an attempted repair by non-authorized
personnel or misuse, alterations, normal wear and tear, or
accidental damage. The defective unit must be returned to
General Tools & Instruments or to a General-authorized
service center, freight prepaid and insured.
Acceptance of the exclusive repair and replacement remedies
described herein is a condition of the contract for purchase of
this product. In no event shall General be liable for any
incidental, special, consequential or punitive damages, or for
any cost, attorneys' fees, expenses, or losses alleged to be a
consequence of damage due to failure of, or defect in any
product including, but not limited to, any claims for loss of
profits.
18