Husqvarna 967 06 23-15 Operator's Manual page 13

7. Push the decompression valve.
To start the product on page 13 for
8. Continue to
more instructions.
To prepare to start with a warm engine
WARNING:
engaged when the product is started to
decrease the risk of injury.
1. Move the front hand guard forward to engage the
chain brake.
2. Set the start/stop switch to on.
3. Push the throttle trigger lockout (A).
4. Push the throttle trigger to open the throttle fully (B).
5. Push the start throttle lock (C).
6. Push the decompression valve.
To start the product on page 13 for
7. Continue to
more instructions.
591 - 003 - 23.02.2021
The chain brake must be
C
A
B
To start the product
WARNING:
a stable position when you start the product.
WARNING:
idle speed, speak to your servicing dealer
and do not use the product.
1. Put the product on the ground.
2. Put your left hand on the front handle.
3. Put your right foot into the footgrip on the rear
handle.
4. Pull the starter rope handle slowly with your right
hand until you feel resistance.
WARNING:
rope around your hand.
5. Pull the starter rope handle quickly and with force.
CAUTION:
rope to full extension and do not let go of
the starter rope handle. This can cause
damage to the product.
a) If you start your product with a cold engine, pull
the starter rope handle until the engine fires.
Note:
You can identify when the engine fires
through a "puff" sound.
b) Disengage the choke.
6. Pull the starter rope handle until the engine starts.
You must keep your feet in
If the saw chain rotates at
Do not twist the starter
Do not pull the starter
13