Guided Tour - Model Lh500 And Lh1000 Front Panel - Hartke LH500 Owner's Manual

Guided Tour - Model LH500 and LH1000 Front Panel

1
3
2
1. Handle – Two convenient metal handles make the amplifier easy to transport and easy to position while
mounting in an equipment rack.
2. PASSIVE Input jack - If your bass guitar has passive circuitry, connect it to the Model LH500 and LH1000 here.
This standard, 1/4" unbalanced jack provides a high impedance (100 k Ohms) input sensitivity of 20 millivolts.
3. ACTIVE Input jack - If your bass guitar has active circuitry,* connect it to the Model LH500 and LH1000 here. This
standard, 1/4" unbalanced jack provides a high impedance (100 k Ohms) input sensitivity of 60 millivolts.
* Bass guitars that have active circuitry normally require a battery for the circuitry to be functional.
4. VOLUME control knob - This is the overall volume control. For best signal-to-noise ratio, keep the output of
your bass at or near maximum and adjust the amp's VOLUME control to the desired level.
5. BRITE LED - The indicator light will illuminate when the BRITE switch is engaged.
6. BASS control knob – As part of the tone stack equalizer, the control is used to adjust the low frequency
response, providing bass boost from 1 to 10.
7. MID control knob - As part of the tone stack equalizer, the control is used to adjust the mid-range frequency
response, providing mid boost from 1 to 10.
8. TREBLE control knob - As part of the tone stack equalizer, the control is used to adjust the high frequency
response, providing treble boost from 1 to 10.
5
6 7
4
13
8 9
10 11
14
4
1
12
15