Table of Contents
Advertisement
Installing and connecting the device
3.2 Installing the IFP Basic and IFP1200 Basic C
3.2
Installing the IFP Basic and IFP1200 Basic C
3.2.1
Notes on installation for IFP Basic
Before installing the device IFP Basic, please ensure that the installation location complies
with the following:
Risk of fire
The device SIMATIC IFP Basic is classified as "OPEN EQUIPMENT" for use in the area of
industrial control equipment in accordance with IEC/EN/UL61010-2-201. In the event of
overheating, the device may discharge burning materials that can cause a fire.
Keep in mind:
• The installation of the device in an enclosure conforming to IEC/EN/UL61010-2-201 is a
Note
If the equipment is used in an manner not specified by the manufacture, the protection
provided by the equipment might be impaired.
• Ensure that the protective contact socket of the building installation is easily accessible
and that there is a mains disconnect switch in switchgear cabinet installations.
• Position the device so that it is not exposed to direct sunlight.
• Position the device so that it is easily accessible for the operator.
• Choose a suitable installation height.
• Ensure that the air vents of the device are not covered as a result of installation. Note the
permitted mounting positions.
3.2.2
Notes on installation for IFP1200 Basic C
Before installing the device IFP1200 Basic C, please ensure that the installation location
complies with the following rules:
NOTICE
Degree of protection for overall device
For the IFP1200 Basic C, observe the related specifications of power supply cable (Page 36),
DisplayPort cable, Type A and Type B cables (Page 40), otherwise, IP65 degree of protection
are voided for the entire device. Spray and water jets as well as penetrating substances can
damage the device.
26
WARNING
mandatory requirement for approval and operation in accordance with IEC/EN/UL61010-
2-201.
Operating Instructions, 06/2023, A5E46178354 - AD
IFP Basic
Advertisement
Table of Contents
