Polaris RANGER 1000 2023 Owner's Manual page 68

FEATURES AND CONTROLS
When the gauge is displaying a fault code, the warning telltale (check engine
or EPS) will blink to indicate which controller set the fault code.
3. To exit the Options Menu the user can select Exit Menu function from
Options Menu, can hold Mode Button and exit out of Options Menu, or not
press any button for 10 seconds, which will exit out of the Options Menu.
DIAGNOSTIC DISPLAY CODE DEFINITIONS
Not all diagnostic codes may be applicable to your vehicle.
Open Load:There is a break in the wires that lead to the item listed in the chart
(injector, fuel pump, etc.), or the item has failed.
Short-to-Ground:The wire is shorted to ground between the electronic control
unit and the item listed in the chart.
Shorted Load:The wires leading to the item listed in the chart are shorted
together, or the item has shorted internally.
Short-to-Battery:The wire leading from the item listed in the chart to the
electronic control unit is shorted to a wire at battery voltage.
COMPONENT
Throttle Position
Sensor
Engine Temperature
Sensor
Intake Air
Temperature Sensor
Manifold Absolute
Pressure Sensor
66
NOTICE
NOTICE
DIAGNOSTIC CODES
CONDITION
Voltage Too High
Voltage Too Low
Voltage Too High
Voltage Too Low
Temperature Too High
Engine Overheat
Shutdown
Voltage Too High
Voltage Too Low
Voltage Too High
Voltage Too Low
Signal Out of Range
SPN
51
51
110
110
110
110
105
105
102
102
102
FMI
3
4
3
4
16
0
3
4
3
4
2