Polaris RANGER 1000 2023 Owner's Manual page 102

MAINTENANCE
8. Using a clean dry cloth, clean the filter sealing surface on the engine
crankcase.
9. Lubricate the O-ring on the new oil filter with a film of fresh engine oil. Check
to make sure the O-ring is in good condition. Install it to specification.
Oil Filter: Turn by hand until filter O-ring contacts sealing surface, then
10. Replace the sealing washer on drain plug.
The sealing surface on the drain plug should be clean and free of burrs, nicks
11. Reinstall the engine crankcase drain plug. Torque drain plug to specification.
12. Remove oil fill cap. Fill engine with recommended engine oil.
13. Verify the transmission is still in PARK.
14. Start the engine and allow it to idle for 30 seconds.
15. Stop the engine and inspect for oil leaks. Wait at least 15 seconds before
removing the dipstick.
16. Unlock the dipstick lever. Remove the dipstick and wipe it dry with a clean
cloth.
17. Reinstall the dipstick and push it into place. Do not lock the dipstick.
Make certain the dipstick is inserted all the way into the dipstick tube to keep
18. Remove the dipstick and check the oil level.
19. Add the recommended oil as necessary to bring the oil level within the SAFE
range on dipstick. Do not overfill.
20. When finished, reinstall the oil fill cap, oil dipstick and lock the lever.
21. Dispose of used oil and filter properly.
100
TORQUE
turn an additional 3/4 turn.
or scratches.
TORQUE
Crankcase Drain Plug: 12 ft-lbs (16 Nm)
the depth of the dipstick consistent.
NOTE
NOTE