Brandt AD658XC1 Instruction Manual

Brandt AD658XC1 Instruction Manual

Decorative hood

Advertisement

Quick Links

INSTRUCTION MANUAL EN
Decorative Hood

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the AD658XC1 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Brandt AD658XC1

  • Page 1 INSTRUCTION MANUAL EN Decorative Hood...
  • Page 2 271 mm 274 mm 600 / 900 mm 500 mm...
  • Page 3 1.3.1 1.3.2 > 70 cm...
  • Page 4 1.4.1 1.5.1 1.5.2 1.4.3 1.4.2 1.5.3 1.4.4...
  • Page 6 Dear Customer, You have just acquired a BRANDT product and we thank you for the trust you place in us. We have designed and manufactured this product with you in mind, your lifestyle, your needs, to respond better to your expectations.
  • Page 7: Important Precautions

    Safety and important precautions These instructions are also available on the web site. Please take heed of this advice when installing and using your appliance. These instructions are intended to protect your safety and the safety of others. Keep this manual with your appliance. If you sell or give the appliance to anyone else, make sure that you also give them this manual.
  • Page 8: Electrical Risks

    Electrical risks • All the power supply circuits must be disconnected before touching the connection terminals. If the power cord is damaged, it must be replaced by the manufacturer, its after-sales service or a similarly qua- lified person in order to avoid any danger.. •...
  • Page 9: Electrical Connections

    Identification USING THE EVACUATION MODE If you possess an outlet to the exterior (fig. 1) Your hood can be connected to this outlet using a flue (minimum diameter Ø mm that is enamelled, in aluminium, flexible or made of inflammable material). If your flue is less than 125 mm in diameter, you must use the recycling mode.
  • Page 10: Assembling The Ventilation Shaft

    — Attach the upper portion of the chimney (C1.5.3) on the metal smoke deflector (A1.5.3) using the two screws (F1.5.3). Before clamping screws complete 4 D and E, adjust the level of the hood. — Adjust the length of the telescoping ventilation shaft by bringing down the lower part and ASSEMBLING THE VENTILATION SHAFT fitting it into the top of the hood.
  • Page 11: Environmental Protection

    Caring for & Environment cleaning CLEANING THE FILTER CARTRIDGES ENVIRONMENTAL PROTECTION They must be cleaned after approximately 30 hours of use or at least once a month. Use — This appliance’s packaging material is recyc- a brush, hot water and mild detergent. Rinse lable.
  • Page 12 CZ5702845_01 08/18...

Table of Contents