Suzuki DF25A 2014 Owner's Manual page 45

4. Warm up the engine for about 5 minutes.
REMOTE CONTROL MODEL
1. Squeeze the fuel line priming bulb several
times until you feel resistance.
2. Make sure that the warm-up lever is in the
fully closed position.
3. Turn the ignition key to the "ON" position.
4. Turn the ignition key to the "START" position.
NOTICE
If you turn the ignition key to the "START"
position for more than 5 seconds, the starter
system could be damaged.
Never turn the ignition key to the "START"
position for more than 5 seconds.
42
NOTICE
If you turn the ignition key to the "START"
position while the engine is running, the
starter system could be damaged.
Never turn the ignition key to the "START"
position while the engine is running.
NOTE:
If the engine fails to start after 5 seconds, wait
10 seconds and try again.
NOTICE
If the Caution System is not working properly,
you may not be alerted to a condition that can
cause damage to your outboard motor.
If the caution lamp does not come on or the
buzzer does not sound when the ignition key
is turned on, the caution lamp or buzzer may
be broken or a failure may exist in the system
circuit. Consult your authorized Suzuki
marine dealer.
5. Warm up the engine for about 5 minutes.