Application Commands - Saitek GM2400 User Manual

Application Commands

Clicking the Application option in the General tab of a command properties page changes
the Action tab at the top to an Application tab. Clicking on this tab brings up the following
screen.
This is a function that will mainly only be used with the P8000 but it can be done for any
controller supported by SGE. Basically, you can assign any button on your controller to
launch an application when you press it. This would only normally be used from within
Windows rather than in a game.
To choose the application you want to assign a command to simply click Browse and then
point it to the .exe file for the application you are looking to run from this button. In the
example below we have associated the button with the NotePad application in Windows.
Here you can choose anything you want – you can even assign the buttons to launch your
favourite games.
You can also access the application setup from the 3D model of the controller as indicated in
the picture below.