Saitek GM2400 User Manual page 22

To set this up we first need to have created our commands in the Command List as
described in the basic section of the manual. You will need to bring the properties of the
Thumb Wheel up on screen so go into the 3D view of the GM2 in your profile and double-click
on the Thumb Wheel. Click the Unshifted tab at the top of the Properties window and then
set the attributes to Banded.
You can then click the Edit Bands button to bring up the following screen.
This Band Editor window with increments from 0 – 100 describes the movement of the
Thumb Wheel. The red line indicates where the Thumb Wheel currently is positioned (at rest
in the centre). If you now move your Thumb Wheel you will see that the red line moves to
correspond with the movement of the wheel. If you move the wheel fully left the red line goes
to zero and if you move the wheel fully right the red line goes to 100.
What we can do here is set it up so that when the wheel reaches a certain position it activates
a command that we have set up. First though, we have to "split up" this axis.