Checking The Engine Oil Level - Toro 02610 Operator's Manual

Figure 10
Checking the Engine Oil
Level
Service Interval: Before each use or daily
1. Move the machine to a level surface.
2. Remove the dipstick and wipe it with a clean
cloth.
3. Insert, but do not screw in, the dipstick into the
oil fill hole.
4. Remove the dipstick and check it.
5. To determine the proper oil level on the dipstick,
refer to Figure
g017340
1. Full
2. High
6. If the oil level is low, slowly pour oil into the oil
fill hole, wait 3 minutes, and check the oil level
on the dipstick by wiping the dipstick clean and
then inserting, but not screwing in, the oil fill
cap into the hole.
Note:
Max. fill: 0.59 l (20 oz.) SAE 10W-30
non-synthetic engine oil with an API series
classification of SJ or higher.
Note:
Fill the engine crankcase with oil until
the dipstick indicates that the engine oil level
is correct as shown in
the engine with oil, remove the excess oil as
directed in Changing the Engine Oil.
7. Install the dipstick and hand tighten it securely.
Important:
first 5 operating hours; change it yearly
thereafter. Refer to Changing the Engine Oil.
9
11).
Figure 11
3. Low
Figure 11. If you overfill
Change the engine oil after the
g017332