Advertisement
10.
Inspection, maintenance and repair
Warning! Disconnect the product from mains before performing any
maintenance or repairs.
Warning! Do not open or disassemble the fixture, it contains no servicable parts
inside. Opening the fixture can be dangerous and will void the warranty.
Warning! Always allow for a cool down period of at least 30 minutes before
touching the lamp or reflector.
Caution! Do not clean the fixture with detergents, abrasives or other agressive
substances.
Caution! Do not touch the inside of the reflector during installation and do not
use water, abrasives or detergents to clean it. This will damage the reflective
surface.
Caution! Wait 20 minutes before activating the fixture after maintenance work
has been conducted.
•
Regularly check the fixture for dust or dirt buildup. Clean if necessary.
Contamination may couse overheating and decreased performance.
- Clean the inside of the reflector only with a soft, dry cloth;
- Clean the electronic ballast and the outside of the fixture using a dry or damp
cloth.
•
Check the lamp monthly for discolorations or black markings. Always replace a
damaged lamp.
Note: Before initial use, the lamp could have black markings. This will disappear
when the lamp runs on full power. If not, replace the lamp.
•
Regularly check the wiring of the product to ensure it is undamaged.
10.1.
Placement and replacement of the lamp
Caution! Do not touch the lamp with bare hands as this will damage the lamp.
Always use a fabric glove to handle the lamp.
Caution! Only use lamps specified by Gavita (see paragraph 3.3).
Note: The lamp must be replaced every year or after 5000 lighting hours,
whichever one comes first.
•
Switch off mains power.
•
Hold the lamp with a fabric glove to prevent it from falling. Use a protective glove
if the lamp is damaged.
•
Open the lamp holders by sliding them outwards (7).
•
Carefully take the lamp out of the fixture (8).
•
Install the new lamp with the getter (A) near the ballast (9), with the glass
vacuum seal pointed downwards (Philips lamp) or sideways (Gavita lamps).
•
Use a fabric glove to carefully press the lamp in the fitting until the metal
springs hold the lamp.
•
Close the lamp holders by sliding them inwards (10).
•
Switch on mains power.
7.
8.
A
9.
10.
Advertisement
