System Board - HP 260 G3 Maintenance And Service Manual

System board

NOTE: All system board spare part kits include replacement thermal material.
1. Prepare the computer for disassembly
2. Remove the access panel
3. In models with a hard drive, remove the hard drive
on page
4. Remove the fan
5. Remove the heat sink
6. When replacing the system board, make sure the following components are removed from the defective
system board and installed on the replacement system board (as applicable):
● Memory modules
● M.2 solid-state drive
● WLAN module
7. To remove the system board:
a. On models with a hard drive, disconnect the speaker cable from the system board (1), and then
remove the three Torx T15 screws (2) that secure the system board to the computer.
(Access panel on page
20.
(Fan on page 28).
(Heat sink on page
(Memory modules on page
(M.2 PCIe solid state drive (SSD) on page
(WLAN module on page
(Preparation for disassembly on page
15).
(Hard drive on page
29).
25)
22)
14).
18) and drive cage Drive cage
21)
System board 31