Table of Contents
Advertisement
3-3. Routing the Tubing
● The tubing can be routed out either from the front or from the bottom. (Fig. 3-6)
● The connecting valve is contained inside the unit. Therefore, remove the front panel. (Fig. 3-6)
(1) If the tubing is routed out from the front, use cutting pliers or a similar tool to cut out the tubing outlet slit (part indicated
by
) from the tubing cover. (Figs. 3-5 and 3-6)
Remove 2 screws
(2) If the tubing is routed out from the bottom, remove the
slit part (
).
● Use a drill bit approximately 13/64 dia. to create holes at
the 4 slit hole indentations (openings).
● Punch out the slit part (
● Be careful not to damage the base plate.
Front
Bottom
Tubing cover
Use cutting pliers or similar
tool to cut cover out
).
Remove 11 panel
screws from front
panel
Fig. 3-5
Indentation
(4 locations)
21
Slit hole
Fig. 3-6
Advertisement
Table of Contents
