Permanent Wiring Installation - Toyotomi Toyostove Laser 560 Operation Instructions Manual

Laser 560_Type A_US.qxd 15.3.26 16:16 ページ 32
WARNING:
Step 1.
Disconnect power
cord from power source.
Remove three (3) screws and
control box cover on the back
of the heater.
Step 2.
Disconnect ground
(green wire) from the power
supply cord bracket.
Step 3.
Disconnect two power
supply wires from right side of
the terminal.
NOTE: Emergency power supply and use of 12V DC batteries with an inverter. Consult your dealer before
attempting to use a battery/inverter system to provide power for your Laser heater. These units require
true sine wave power for proper long-term operation. Some types of modified or block sine wave
inverters will cause damage to the electrical components of the heater. Several inverter
manufacturers offer true sine wave inverters which should operate the unit without any problems if
properly sized and configured. If you have any questions about appropriate power supply, consult your
authorized TOYOSTOVE dealer.
32

PERMANENT WIRING INSTALLATION

MAKE SURE POWER SUPPLY CORD IS DISCONNECTED TO AVOID ANY ELECTRIC SHOCK
BEFORE SERVICING. ELECTRIC SHOCK MAY CAUSE SERIOUS INJURY.
INSTALLATION SHOULD BE CONDUCTED BY A LICENSED ELECTRICIAN.
supply
wire
Step 4.
Squeeze strain relief with the
adjustable pliers to remove
plastic bushing from the pow-
er supply cord bracket.
Remove the power supply
cord.
Step 5.
Insert the power supply cable
from junction box and con-
nect ground wire to the power
supply cord bracket and pow-
er wires to the
terminal.
Step 6.
Affix the control box cover to
the heater and insert screws.