7.
Using the dimensions shown in
locate, mark, and drill 2 holes in the top of the
seat shroud.
Important:
Use caution when drilling these
holes; electrical components and control
cables are located under the seat shroud.
Figure 10
1. 21 mm (13/16 inch)
8.
Insert the mounting side of the receiver end of
each seat-belt lock assembly into one of the
newly drilled holes in the seat base
Figure 11
9.
Mount the receiver end of each seat-belt
assembly to each seat-belt anchor with a bolt
(7/16 inch) and nut (7/16 inch) as shown in
Figure
11.
10.
Torque the bolts to 67 to 83 N∙m (49 to 61 ft-lb).
Figure
10,
g026313
2. 51 mm (2 inches)
(Figure
11).
g026314
11
Routing the Wire Harness
Parts needed for this procedure:
1
Wire harness
1
Clip tie
1
Plug
1
Fuse (30 A)
Procedure
Note:
For Workman MDE machines, the 12 V Plug
Adapter Kit (sold separately) must be installed on the
machine; refer to the Installation Instructions for the
kit.
1.
Route the wire harness via 1 of the 2 following
options:
•
Route the wire harness under the control
panel (Box A of
in the lower hole on the side panel and the
plug in the top hole.
•
Drill a hole into the console, install the clip tie
in the top hole on the side panel, and install
the plug into the lower hole (Box B of
12).
Important:
hole; electrical components and control
cables are located under the seat shroud.
10
Figure
12). Install the clip tie
Use caution when drilling this
Figure