Water Saving Program; Tub Clean Program; Delay Start Course - Samsung WA85GWG User Manual

setting up your washer

Water Saving program

This is a specifi cally designed course that enables you to wash laundry effectively with low amounts
of water. Water Saving, Cold&Hot, Water Level 7 is recommended for a normally soiled cotton load."
1. Add the laundry into the tub and close the door.
2. Press the Power button to turn the washer "On".
3. Press the Program button to select the Water Saving course.
4. Press the Water Level button to display level "7".
5. Press the Water Supply button to display "Cold" & "Hot".
6. Press the Start/Pause button.
• To pause a program, press the Start/Pause button again. You can change the program
when it is paused.
7. Add detergent and fabric softener to the Magic Detergent Compartment according to the
water level and close the cover.
8. Press the Start/Pause button.

Tub Clean program

Use this program to clean the tub. It will keep the tub clean and sanitary.
1. Close the door.
2. Press the Power button turning the washer "On".
3. Press the Program select button.
4. Press the Start/Pause button.
To pause a program, press the Start/Pause button again. You can change the program
when it is paused.
• Never place laundry in the tub when cleaning inside the tub, as this can cause
discoloration or damage to the laundry.
• When doing the laundry after cleaning the tub, you may fi nd some impurities. These are
just detergent residues and impurities after the tub cleaning. Perform the rinse cycle two
to three times.
• The initial water level is selected at the display water level "6".
• You cannot select the 'Hot' option for the water supply for this program.
5. Press the Start/Pause button.

Delay Start Course

Use this to specify a time for the wash cycle to start, for example, when you need to go out and
are unable to monitor the washer.
1. Add the laundry into the tub and close the door.
2. Press the Power button to turn the washer "On".
3. Press the Program select button.
4. Press the Delay Start button.
You may set the delay end time using the Delay Start button from between 3 to 19 hours.
5. Press the Start/Pause button.
6. Add detergent and softener to the Magic detergent compartment according to the water
level and close the door.
The wash will fi nish by the set time.
• Detergent must be added into the detergent drawer.
• If detergent is added onto the laundry directly, some clothes may become discolored
because the start has been delayed.
• To cancel a Delay Start, press the Power button.
7. Press the Start/Pause button.
14_ setting up your washer 14_ setting up your washer
WA85GWWIP-03222A-03_EN.indd Sec3:14 WA85GWWIP-03222A-03_EN.indd Sec3:14 2013-01-29 2013-01-29 2:42:35 2:42:35