30
CLASSIC OUTDOOR FURNACE • OWNER'S MANUAL
SERVICEABLE ITEMS
NOTE: These procedures should be performed by a qualified individual and in accordance
with any and all federal, state/provincial and local codes and regulations. When
performing work on an appliance observe all precautions in the literature, tags and labels
attached to the appliance and other safety precautions that may apply. When working
with electricity and electrical components, failure to follow precautions could result in
property damage, personal injury or death.
NOTE: If any of these items are under warranty, remember that the warranty covers only
the cost of the replacement part. Labor is not covered.
NOTE: Use only genuine Central Boiler parts and accessories if it ever becomes necessary
to replace any component on the outdoor furnace.
FIREBOX DOOR CAM LOC ADJUSTMENT
If the firebox door rope has been replaced and it is not sealing properly, the
firebox door may need to be adjusted to close more tightly. When adjusting the
firebox door, make sure it is not adjusted too tightly as damage to the firebox
door, frame or door rope may result.
1.
Loosen the adjustment nut (two nuts on the dual Cam Loc® style door)
and slide the lock assembly in slightly toward the furnace; then tighten
securely. On the dual Cam Loc doors, make sure to adjust both the top
and bottom for equal pressure when latched.
Dual Cam Loc Style
Door top view
FIREBOX DOOR SEAL ROPE
The firebox door seal must be in good condition to ensure an airtight seal. If
replacement is necessary due to the firebox door seal becoming damaged or
brittle, use the following procedure:
1.
Disconnect power to the furnace. Open the firebox door.
Single Handle Style
Cam Loc
Adjustment
Door side view