Mounting Instructions; Terminal Connections - M-system R7I4DML3-DAC32C Instruction Manual

MOUNTING INSTRUCTIONS

■ DIN RAIL MOUNTING (PARALLEL)
• Mounting
1) Set the upper hook at the rear side of the unit on the DIN
rail.
2) Push in the lower.
1
• Dismounting
1) Push down the DIN rail mounter slider with tip of a mi-
nus screwdriver.
2) Pull the lower of the unit.
3) Remove the upper hook of the unit from the DIN rail.
3

TERMINAL CONNECTIONS

Connect the unit as in the diagram below.
■ EXTERNAL DIMENSIONS unit: mm [inch]
2
2
1
186 [7.32]
172 [2.83]
165 [6.50]
5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: info@m-system.co.jp
■ SURFACE MOUNTING
1) Insert the two DIN rail mounter sliders until it clicks
once, as shown below.
1
2) Mount the unit with M4 screws referring the External
Dimensions. (Torque: 1.4 N∙m)
2-4.3 [.17] dia
4 [.16] deep
R7I4DML3-DAC32C
1
41 [1.61]
DIN rail
(35mm wide)
(4 [.16])
EM-8008-B P. 5 / 12