Error Messages/Troubleshooting - Sanitas SBC 15 Instructions For Use Manual

• Press the memory button M.
PM PM flashes on the display.
The average value of the evening
measurements for the last 7 days is
displayed (evening: 6.00 p.m. – 8.00
p.m.).
• When you press the memory button
M again, the last individual measure-
ment is displayed (in this example,
measurement 03).
• When the memory button M is pressed again, you
can view your individual measurements.
• To switch the device off again, press the START/
STOP button .
You can exit the menu at any time by pressing
the START/STOP button .
30
• To clear the memory of the relevant user memory,
you must first select a user memory.
• Start the retrieval of the average measured values.
A flashes on the display and the average value of
all saved measured values in this user memory is
displayed.
• Press and hold the memory button M and the
START/STOP button
on the user memory you are in.
All values of the current user memory
are deleted and the device switches
off.

8. Error messages/troubleshooting

In the event of errors, the error message
the display.
Error messages may appear if
• the systolic or diastolic pressure could not be meas-
ured ( or appears on the display)
• the systolic or diastolic pressure was outside the meas-
urement range ("Hi" or "Lo" appears on the display)
• the cuff is fastened too tightly or too loosely
( or appears on the display)
for 5 seconds, depending
_ appears on