Table of Contents
Advertisement
Steps 8 to 10 for LP unit only:
8) Loosen 6 screws that secure the burner extenders on burner tray,
located behind the burner on either side of the pilot assembly.
9) Lift out the 2 burner tray extenders.
Burner tray
Burner tray extenders
10) After extenders have been removed, remove the 2 screws that
secure the burner tray, at the base of the firebox.
11) Slide the burner to the left and lift it out.
Location of screws securing burner
12) Remove 8 screws to remove the fan access panel cover - located on
the left hand side floor of the firebox.
Fan Access Panel
Burner tray extenders
13) Manoeuvre the fan into position on the floor of the unit. Tilt the fan to
get through the fan access panel and into position.
14) Secure the fan to the floor of the unit with 2 screws.
15) Attach the ground wire from the fan and the power cord to the ground
lug in the unit. The ground lug is located just in front of the receptacle
box on the left side on the floor of the unit.
Ground Lug
16) Slide the thermodisc into the bracket on the bottom side of the fan
access panel - check fan access panel gasket - replace if necessary.
Regency Horizon ® HZ54E-11 Gas Fireplace
installation
|
51
Advertisement
Table of Contents
