Makita DLM537 Instruction Manual page 18

5. To remove the individual mower blade, turn the
bolt counterclockwise with box wrench 17 while holding
the base plate.
1
Fig.43
► 1 . Base plate 2. Mower blade 3. Box wrench
6. Remove the nut, washer, spring washer, mower
blade, and bolt in order.
1
5
6
Fig.44
► 1 . Bolt hole 2. Bolt 3. Mower blade 4. Spring washer
5. Washer 6. Nut
2
1
2
3
1
2
3
4
NOTICE:
When tightening the nuts to install the
individual mower blades, apply 30 N•m as tighten-
ing torque.
NOTICE:
When installing the individual mower
blade, be sure to attach the spring washer in the
direction as shown in the figure.
NOTICE:
When installing the individual mower
blade, be sure to insert the bolts into the bolt
holes shown in the figure.
Installing the mower blade
WARNING:
It has a top/bottom facing.
WARNING:
to secure the blade.
WARNING:
and all the fixing parts are installed correctly and
tightened securely.
WARNING:
always follow the instructions provided in this
manual.
NOTICE:
After installing the mower blades,
remove the pin from the mower body.
To install the mower blades, perform the removal proce-
dure in reverse.
1
18 ENGLISH
Install the mower blade carefully.
Tighten the bolt clockwise firmly
Make sure that the mower blade
When you replace the blades,