Makita DLM537 Instruction Manual page 17

Removing or installing the mower
blade
WARNING:
The blade coasts for a few sec-
onds after releasing the switch. Do not start any
operation until the blade comes to a complete
stop.
WARNING:
Always remove the lock key and
battery cartridge when removing or installing the
blade. Failure to remove the lock key and battery
cartridge may cause a serious injury.
WARNING:
Always wear gloves when han-
dling the blade.
Removing the mower blade
For models equipped with straight mower
blade
1.
Put the mower on its side so that the mowing
height adjusting lever comes to the upper side.
2. To lock the blade, insert the pin supplied with the
machine into a hole on the mower body.
3. Turn the bolt counterclockwise with box wrench
17.
3
Fig.39
► 1 . Mower blade 2. Pin 3. Box wrench
4. Remove the bolt, and then mower blade.
1
2
3
Fig.40
► 1 . Blade support 2. Mower blade 3. Bolt
4. Protrusion
NOTICE:
sure that the protrusions on the blade support fit
in the holes in the mower blade.
For models equipped with swing back
mower blades
1.
height adjusting lever comes to the upper side.
2.
the machine into a hole on the mower body through a
hole on the base plate.
3.
17.
3
2
Fig.41
► 1 . Pin 2. Base plate 3. Box wrench
1
4.
4
Fig.42
► 1 . Blade support 2. Base plate 3. Bolt 4. Protrusion
NOTICE:
make sure that the protrusions on the blade sup-
port fit in the holes in the base plate.
17 ENGLISH
When installing the mower blade, make
Put the mower on its side so that the mowing
To lock the base plate, insert the pin supplied with
Turn the bolt counterclockwise with box wrench
Remove the bolt, and then base plate.
1
When installing the mower blades,
1
2
4
2
3