Table of Contents
Advertisement
CONTENTS
Hex Key 2.5mm, Hex Key 5.0mm, Safety Guard , Handles (3)
Safety Strap, 3MT Set Screw Arbor, 3MT Drift Key, Coolant Tank Assembly
ARBORS
Set Screw Arbor Accepts Standard ¾" Weldon Shank Annular Cutters.
Annular Cutter Depth Of Cut Capacity Is 2". 4" Depth Of Cut Can Be Achieved By Using 2 Piece Pilot Pin.
*Additional Arbors and Drill/Chuck Adaptors available for purchase.
Contact Champion directly for information.
MAGNETIC DRILL PRESS SPECIFICATIONS
POWER INPUT
1600 W (13.3A)
110 / 120V
VOLTAGE
MOTOR SPEEDS
Speed 1: 50-140, Speed 2: 80-230
Speed 3: 120-330, Speed 4: 180-510 RPM
MAGNETIC
STRENGTH
3800 lb (1723 kg)
INTENDED USE
The intended use of this magnetic drill is to drill holes in ferrous metals. The magnet is used to hold the drill in
place whilst the drill is functioning. It is designed for use in fabrication, construction, railways, petrochemical
and any other applications when drilling ferrous metal.
Any deviation from its intended use will not be covered by warranty.
GENERAL SAFETY RULES
WARNING! Follow all instructions listed below to prevent electric shock, fire and/or serious personal injury.
Cancer & Reproductive Harm. See P65warnings.ca.gov for more info.
WORK AREA
1.
Keep your work area clean and well lit. Cluttered benches and dark areas invite accidents.
2.
Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids,
gases or dust. Power tools create sparks which may ignite the dust or fumes.
3.
Keep bystanders, children and visitors away while operating a power tool. Distractions can cause you
to lose control.
ELECTRICAL SAFETY
1.
Grounded tools must be plugged into an outlet properly installed and grounded in accordance with
all codes and ordinances. Never remove the grounding prong or modify the plug in any way. Do not
use any adaptor plugs. Check with a qualified electrician if you are in doubt as to whether the outlet is
properly grounded. If the tools should electrically malfunction or break down, grounding provides a low
resistance path to carry electricity away from the user.
2.
Avoid body contact with grounded surfaces such as pipes, radiators, ranges and refrigerators. There is
an increased risk of electric shock if your body is grounded.
3.
Do not expose power tools to rain or wet conditions. Water entering a power tool will increase the risk of
electric shock.
4.
Do not abuse the cord. Never use the cord to carry the tools or pull the plug from an outlet. Keep cord
away from heat, oil, sharp edges or moving parts. Replace damaged cords immediately. Damaged
cords increase the risk of electric shock.
5.
When operating a power tool outside, use an outdoor extension cord marked" W-A" or" W". These
cords are rated for outdoor use and reduce the risk of electric shock.
6.
Use With 110/120V Supply Only.
7.
Do not use on DC Supply.
8.
Do not use magnetic drill on same structure when arc welding is in progress.
BD100 Manual
ANNULAR CUTTER CAPACITY*
TWIST DRILL CAPACITY*
MACHINE DIMENSIONS
NET WEIGHT
2
4" DIAM X 4" DEPTH
1-1/4" DIAM
HEIGHT: 20-1/16 to 27-15/16
WIDTH: 12-3/16"
OAL LENGTH: 13-3/8"
61 lbs (28 kg)
championcuttingtool.com
Advertisement
Table of Contents
