Remote Control - Violectric HPA V550 PRO User Manual

THE REMOTE CONTROL FOR VIOLECTRIC HPA V550
Function
This remote control sends out infrared rays. For that purpose, there is
an infrared LED on the front. The remote control should point in
direction of the target device to obtain best functionality.
The operating distance is about 5 - 7 meters (15 – 20 ft).
With the "VOLUME +/-" buttons the volume can be altered. This is done
with a motor inside the amp to get the volume knob into motion.
With the "MUTE" button the internal mute function is engaged.
A direct "MUTE" can only be released by the remote control.
With the "INPUT 1 / 2 / 3" buttons one of the three analogue inputs may
be selected.
With the "Head-Output" and "Line-Output" buttons you may chose if
the front mounted headphone outputs are active or the rear mounted
line outputs – or both or none.
(pictures show the original size
of the remote control)
Maintenance
The remote control is powered by a little "CR2032" size lithium battery.
The battery diameter is 20 mm, the hight is 3,2 mm – that´s where the
name comes from.
If you share the opinion that the battery is empty you may check this
with the aid of your smartphone. The camera function reacts on the
infrared rays of the remote control which cannot be seen with human
eyes.
So, just point the remote control to the camera of your smart phone
and press a button. When you don´t see any action, the battery is
empty.
Take a paperclip or something similar and bend it like indicated on the
back of the remote control. Plug it in the little hole to force the keypad
to come out the aluminum frame – it is held by magnets.
Now you can carefully take off the electronics to replace the battery.
The (-) pole must point to the PCB.
The (+) pole is the wider part and normally denoted.
It has to point "upwards".
Re-assemble the keypad, take care of the infrared LED !
11