Table 3-1 gives a quick overview of the RS-440 installation process. The sections
following this one provide detailed instructions.
Installation should be performed by a qualified custom video
Note
installation specialist.
Table 3-1. Installation Overview
Step
Choose a location for the projector
1
If installing an RS-440LT/CineWide: Install CineWide
2
lens base plate (optional)
Mount the projector
3
Connect signal sources to the RS-440
4
Connect external controller to RS-232 port (optional)
5
Connect 12-volt trigger output to retractable screen or
6
other, 12-volt trigger-activated equipment (optional)
7
Apply power to the projector
Change the OSD Language (optional)
8
For rear-screen and/or ceiling-mount installations, select
9
the proper picture orientation
Primary lens adjustments: projected image size (zoom),
10
position (shift) and focus
11
Install CineWide anamorphic lens (optional)
CineWide lens adjustments: position, pitch (angle),
12
geometry and focus
Projector calibration: adjust the following for each input;
save settings when finished:
Aspect ratio
Brightness
13
Contrast
Color level
Tint
Input position
Runco RS-440 Installation/Operation Manual
Procedure
For Details, Refer to
page...
14
20
22
23
28
29
29
30
30
17, 31
33
33
44 through 49
13
Installation
3.2
Quick Setup