Assembling The Kit - Toro Titan 136-1654 Installation Instructions Manual

Assembling the Kit

Assemble the kit as shown in
Figure 3 to determine which hole to use in the upper mount.
Note:
Install the lower support bracket only if you are mounting the kit in front of the rear tires. Install the
bracket so that the large face is oriented rearward on the machine;
for mounting the kit on the left side of the machine.
1. Main bracket
2. Fist clamp (optional)
3. Slotted screw
Note:
Mounting the fist clamp is optional. If mounting the fist clamp to the main bracket is inconvenient for
mounting some accessories, you may alternatively mount it to a bucket (sold separately); drill a hole (5.1 mm or
0.2 inch diameter) into the bucket and mount the fist clamp to it using the slotted screw and locknut.
Figure 2. Ensure to loosely install the upper mount to the main bracket; refer to
4. Top bracket
5. Carriage bolt (5/16 x 7/8
inch)
6. Welded support bracket
Figure 2
Figure 2
7. Nut (5/16 inch)
8. Lower support bracket (if
needed)
9. Upper mount
3
shows the bracket orientation
10. Knob
11. Locknut (#8)
g037140