Table of Contents
Advertisement
Mounting the Kit in Front of the Rear Tires
1. Secure the mount assembly to the console cover using 2 bolts (5/16 x 1 inch) and 2 nuts (5/16 inch) as
shown in
Figure 5
2. Tighten the fasteners securing the upper mount to the main bracket.
3. Secure the lower support bracket to the rear side of the bracket under the console cover using 1 bolt (5/16
x 1 inch) and 1 nut (5/16 inch) as shown in
Note:
You will not use the bottom hole in the main bracket or lower support bracket.
Note:
Ensure that the assembly is vertical. If it hangs at an angle, the lower support bracket may be
upside down.
1. Nut (5/16 inch)
2. Mount assembly
1. Nut (5/16 inch)
2. Mount assembly
or
Figure
6.
Mounting the kit to the left side of the machine
3. Console cover
4. Bolt (5/16 x 1 inch)
Mounting the kit to the right side of the machine
3. Console cover
4. Bolt (5/16 x 1 inch)
Figure 5
or
Figure
6.
Figure 5
Figure 6
5
5. Lower support bracket
5. Lower support bracket
g213937
g213522
Advertisement
Table of Contents
