Black Max BM10500 Series Operator's Manual page 16

Hide thumbs Also See for BM10500 Series:
Table of Contents

Advertisement

INSTALLING THE WHEELS
See Figure 5.
Wheels are provided to assist in moving the generator to
the desired location and should be installed on the side
opposite the handle.
 Locate the following items:
2 bolts (3/8-16 x 4-1/4 in.)
2 washers (3/8 in.)
2 spacers (.38 ID)
2 wheels
2 lock nuts (3/8-16)
 Raise the end of the generator opposite the handle high
enough to gain access to the frame bottom; securely
position props underneath to support.
 Insert a wheel spacer into the center of the wheel.
 Place a washer on the bolt, then slide bolt through the
wheel.
 Slide the bolt through the U-bracket frame on
generator.
 Install nut on bolt and tighten securely.
 Repeat the process on the other side to install second
wheel.
ASSEMBLy
SECURING THE HANDLE
See Figures 6 - 9.
 Locate the following items:
Handle
Bolt (5/16-8 x 3/4 in.)
Bolt (5/16-18 x 1-3/4 in.)
2 washers (5/16)
2 flange nuts (5/16-18)
Handle bracket spacer
Handle lock bracket
Handle lock pin
Lanyard
 Align the bracket on the handle with the holes on the
generator frame as shown. Place a washer on the 3/4 in.
bolt, then slide bolt through the top hole in the bracket
and the generator frame.
 Install flange nut and tighten securely.
 Align the bracket on the other side of the handle with the
holes on the generator frame as shown. Place a washer
on the 1-3/4 in. bolt, then slide bolt through the top left
hole in the bracket and the generator frame.
 Slide the handle bracket spacer on the bolt as show in
figure 7. The bolt should extend through the top left hole
on the spacer and the raised pin on the spacer should fit
in the top right hole on the generator frame.
 Install flange nut and tighten securely.
 Attach the lanyard to the handle lock pin and the handle
as shown in figure 8.
 Insert the pin through the hole in the handle, generator
frame, and handle bracket spacer to secure handle in
place.
WARNING:
Do not attempt to lift the unit by the handle assembly. If it is
necessary to lift the generator, always grasp by the frame.
Use proper lifting techniques to avoid back injury.
Page 12 — English

Advertisement

Table of Contents
loading

Table of Contents