Table of Contents
Advertisement
OPERATION
AUXILIARY INPUT
The unit can be connected a portable audio
player through the AUX IN interface. And
press MODE button to switch AUX IN
mode when inserted an audio source to the
unit.
MEMORY FUNCTION
When B+ wire and Acc wire is off. It can
memory the radio's preset stations.
LIQUID CRYSTAL DISPLAY
Exhibit current frequency and activated
functions on the display.
RESET FUNCTION
Press MODE button switch to AUX mode
then press and hold
seconds around to active the RESET
function. The RESET function is to be
activated for the following reasons:
-
Initial installation of the unit when all
wiring is completed.
-
All the function buttons do not operate.
-
Error symbol on the display.
SLIGHT FOG AFTER OPERATION
Normal in colder weather. Allow radio to run
for 1-2 hours, this will burn off moisture.
RADIO OPERATION
SWITCHING TO RADIO MODE
Press MODE button (2) to select radio
mode, the radio mode appears on the
display together with the memory band
and frequency.
SELECTING THE BAND
At radio mode, press BAND button (1)
shortly to select the desired band.
The reception band will change in the
following order:
button for 6
→FM1→ FM2→ FM3→ AM (MW) 1→ AM (MW) 2
SELECTING STATION
Press
button (10) or
shortly to activate automatic seek
function. It will search up/down a station
automatically. Press for 2 seconds until
"MANUAL" appears on the display, the
manual tuning mode is selected. In this
mode you can turn up/down a step
frequency one by one till searched a
station. If both buttons have not been
pressed for several seconds, they will
return to seek tuning mode and "AUTO"
appears on the display.
MANUALLY STATION STORING
To receive a station, Press and hold the
button (5) for 2 seconds. It will
show "SAVE CH1". If you want to store
the station to CH2. Shortly press it again
it will show "SAVE CH2". In this moment
press and hold the
seconds. The current station is stored
into the CH2.
PRESET STATIONS SELECTING
Press the
the preset station (CH1~6).
AUTOMATIC MEMORY STORING
Press BAND button (1) for 2 seconds,
the radio searches from the 87.5MHz
frequency and checks the signal
strength until one cycle search is
finished. And then some stations are
stored into the corresponding preset
number button. In the first cycle it will
in LOCAL mode to receive the
stronger station. If it is less than 18
pcs station it will searching stations in
nd
2
cycle in DX (distance) mode.
USB PLAY OPERATION
On the back side of the unit, there is a USB
interface . You can connect an USB driver
8
button (9)
button (5) for 2
button shortly to select
Advertisement
Table of Contents
