Table of Contents
Advertisement
8
4
3
5
6
Figure 2
1. Bolt, 5/8 x 7/8 in.
(22.5 mm)
2. Lock washer, 5/16 in.
3. Washer, 5/16 in.
4. Stud
3. Slide the hose clamp onto the fuel line (Fig. 2).
4. Push the fuel line onto the fuel tank connection and
secure it with a hose clamp (Fig. 2).
Install Upper Handle
1. Align upper handle with upper mounting holes in rear
frame (Fig. 3).
2. Secure each upper mounting hole with a flange bolt
(3/8 x 1 in. (26mm)) and flange nut (Fig. 3). Torque
bolts to 25 ft. lbs. (34 N.m).
3. Select high, medium or low position for the lower
mounting hole (Fig. 3). This allows the upper handle
to be adjusted to the user's height preference.
4. Secure each lower mounting hole with a flange bolt
(3/8 x 1 in. (26mm)) and flange nut (Fig. 3). Torque
bolts to 25 ft. lbs. (34 N.m).
All manuals and user guides at all-guides.com
7
3
5
6
m–5339
5. Spring
6. Locknut
7. Hose clamp
8. Fuel tank connection
15
2
6
Figure 3
1. Upper handle
2. Rear frame
3. Flange bolt, 3/8 x 1 in.
4. Flange nut, 3/8 in.
Install Control Rods
Before installing and adjusting control rods loosen quick
release levers and move reference control bar all the way
forward.
Left Control Rod
1. Slide clevis pin through rod fitting and mounting hole
in control bracket (from outside). Secure with washer
and hairpin cotter (Fig. 5).
2. Remove hairpin cotter and rod from upper control bars
(Fig. 4).
3. Press and hold upper control bars against reference
bar, so stop hits (Fig. 4).
7
8
m–5336
5. Upper mounting hole
6. Lower mounting hole
7. Low position
8. High position
Advertisement
Table of Contents
