Emerson Rosemount 1410S Quick Start Manual page 27

June 2023
Note
Always make sure cable is rated for ambient temperature of the end
installation.
4.5 Terminating resistors
Three DIP switches are provided to enable termination and biasing
resistors to the serial Modbus connection.
See 1410S Reference Manual
4.6 Connect to the host system
Connect the Gateway's Ethernet 1 (Primary) or serial Modbus Output
connection to the Host System Network or Serial I/O.
Refer to
connections.
4.7 Best practice
Twisted shielded pair cable is generally used to wire the serial
connection, and it is standard practice to ground the shield on the
serial host side leaving the shield floating on the gateway side.
Insulate the shield to avoid grounding issues.
4.7.1 Security best practices
For security best practices, please see Emerson Wireless Security
Whitepaper. User is solely responsible for the security of their system
and products installed on such systems. These recommendations are
in addition to user's product and cybersecurity policies.
Quick Start Guide
1410S Reference Manual
for more information.
for additional instruction on host
Quick Start Guide
27