00 G3
00
MHz
SET
²
º
Using the devices
To establish a transmission link, proceed as follows:
1. Switch the receiver on.
2. Switch a transmitter on.
The transmission link is established and the receiver's RF level display "RF" reacts.
If you cannot establish a transmission link between transmitter and receiver:
Make sure that transmitter and receiver are set to the same frequency bank and to the
same channel.
If necessary, read the chapter "If a problem occurs ..." on page 28.
It is vital to observe the following notes:
Make sure that the desired frequencies are listed in the enclosed frequency
information sheet.
Make sure that the desired frequencies are approved and legal in your country
and, if necessary, apply for an operating license.
Switching the devices on/off
EM 100 receiver
To switch the receiver on:
Briefly press the
The receiver switches on and the
To switch the receiver to
standby
If necessary, deactivate the lock mode (see page 21).
Keep the
STANDBY
When in the operating menu, pressing the
(ESC function) and return you to the current standard display.
º
²
.
STANDBY
button
"Receiver
Parameters" standard display appears.
mode:
²
button
pressed until "OFF" appears on the display panel.
STANDBY
Using the devices
²
button
will cancel your entry
17