Advertisement
times. Go back to Settings->System->Developer options menu to turn off
the""Disable absolute volume"". Disconnect and reconnect the two devices
through Bluetooth.(Note: You could find this option from Setting-Audio if your
are using the firmware above FW1.0.3.)
9. How to enable the coaxial and optical output of R7?
You could enable the OPT/COAX output from system
setting-Audio-OPT/COAX output option.
[R7 optical / coaxial no output]
Please enable the OPT/COAX output from system setting-Audio-OPT/COAX
output option first.
Note: When the optical/coaxial output switch is turned on, the output will follow
the standard SPDIF protocol specification.
Maximum supported sampling rate:
COAX OUT: 384kHz/24bit; DSD128 (DOP)
OPT OUT: 192kHz/24bit
The tracks exceeding the maximum sampling rate will be SRC before
outputting.
[The sample rate will show in the status bar when using coaxial / optical
output?]
The coaxial/optical output port of R7 is independent. The analog output and
digital output can output at the same time. Besides, the XLR connector is
without detection, so there is no distinction for analog output and digital output.
[No output from coaxial/optical output port in coaxial and optical
decoding mode?]
Coaxial/optical decoding mode does not support coaxial/optical output.
Advertisement
