Subscribe to Our Youtube Channel
Related Manuals for Stern ARTIS H
Summary of Contents for Stern ARTIS H
- Page 1 ARTIS H ELECTRONIC CISTERN FOR WC WITH IRON FRAME IN STA LLAT I ON A ND MAI NTEN A NCE GUIDE IN STA LLAT I ON A ND MAI NTEN A NCE GUIDE...
-
Page 2: Pre-Installation
The tradenames, trademarks, logos and service marks presented in this document, including their design, are the property of Stern Engineering Ltd or other third parties and you are not permitted to use them without the prior written consent of Stern Engineering Ltd or such third... -
Page 3: Pack Contents
(QTY: 1 1 ) ) (QTY: (QTY: 1 1 ) ) DUST COVER DUST COVER (QTY: (QTY: 1 1 ) ) ARTIS H PANEL ARTIS H PANEL WALL ANCHORING SET: WALL ANCHORING SET: THREADED ROD & THREADED ROD & PLASTIC SLEEVE SET AND WASHER... -
Page 4: Technical Data
TECHNICAL DATA INSTALLATION ARTIS H - CONCEALED CISTERN INSTALLATION Artis Floor and Wall Mounting: The installation of the toilet anchoring bolts height will be set according to the installed model only. Adjust the two legs (A1) of the Cistern Iron Frame to the desired height. - Page 5 INSTALLATION ARTIS - CONCEALED CISTERN INSTALLATION ARTIS H - CONCEALED CISTERN INSTALLATION Toilet Support Rod Assembly Use a screwdriver to install the two Bowl Support Threaded Rods (1) into the Pipe Assembly cistern frame. Use either the external or Fasten the Waste Pipe mounting clip...
- Page 6 Access & Control Panel Installation Use a standard wall-hung toilet bowl (not supplied with the Artis H) Caution: switch off the electrical and water supplies to the Cistern before proceeding with this Bowl Support part of the installation.
- Page 7 INSTALLATION INSTALLATION Artis panel installation Important: Check that no objects are in front of the sensor besides the washbasin. Open the Internal Panel to reveal the internal part of the cistern. Turn OFF the Shut off valve Note: there should be no water flow since the main water system is still Now, remove the protecting sticker switched off.
-
Page 8: Settings Adjustment
SETTINGS ADJUSTMENT SETTINGS ADJUSTMENT DELAY IN TIME: If required, the delay in time can also be modified as follows: Press the IN button. Wait until a quick flashing of the blue light DETECTION DELAY OUT TIME in the sensor eye is perceived. Then, press + to increase the delay in time RANGE and –... -
Page 9: Functionality Testing
Snap out the Internal Panel to obtain access to the internal part of the tank. Walk away from the cistern (after staying in front of it for at least 5 seconds) to activate the touch free short or long flush. The Artis H is now ready for use. -
Page 10: Maintenance & Battery Replacement
If a defect is found in normal use, Y. Stern Engineering Ltd. will, at its discretion, repair, Pull out the filter which is located inside provide a replacement part or product, or make appropriate adjustments. -
Page 11: Spare Parts
SPARE PARTS TROUBLESHOOTING PROBLEM INDICATION CAUSE SOLUTION Seals & Screws Kit 07210193 Sensor range is not set Increase or decrease the sensor The sensor’s properly. range. blue LED The sensor is picking up Panel Kit & Sensor 07040338 indicator DOES NOT reflections from a mirror or Eliminate cause of Cistern does not... - Page 13 777 Passaic Avenue, Clifton NJ,07012, USA Tel: +1-973 773 8011 | Fax: +1-973-779-8768 Toll Free: 1-800-4364410 info@sternfaucets.com | tech@sternfaucets.com 01.22 01500533-A...
Need help?
Do you have a question about the ARTIS H and is the answer not in the manual?
Questions and answers