Specification - Lanner electronics EM-551Series Manual

Embedded sbc with ssd, three-lan and ns geode gx1 low-power cpu
Table of Contents

Advertisement

INTRODCTION
1.1 S
PECIFICATION
Processor
o
Chipset
o
System Memory / RAM : 32 MB SDRAM on-board
o
Ethernet Controller
o
IDE Interface
o
Floppy Drive Interface
o
Serial Port
o
Parallel Port
o
Universial Serial Bus
o
Keyboard/Mouse
o
connector
RTC
o
BIOS
o
Power management
o
Power Connector
o
Operating Temperature : 0°C ~ 60°C
o
Storage Temperature
o
Humidity
o
Dimensions
o
Net weight
o
EMI/EMS
o
Note
o
: NS Geode GX1 300 MHz Low-Power CPU on-board
: NS CS5530A, Realtek RTL8139C, Winbond 83977F
: Three Realtek RTL8139C, support three-10/100 Base-T
interface with Link and Active signal header
: Two PCI IDE port, support up to four IDE devices. Supports
PIO mode 4 and Bus Master. Also supports Multi-word DMA
and Ultra DMA/33. (one 90 degree and one 180 degree)
: One FDD port , support two floppy devices
: One COM port
: One Multi-mode parallel port ( SPP/EPP/ECP )
: Two USB ports
: One 6-pin mini-DIM PS/2 keyboard/mouse connector on-board.
: Internal RTC with Li battery
: 256KB Award license BIOS
: I/O peripheral devices support power saving and
doze/standby/suspend modes. APM 1.2 compliant.
: On-board 4-pin power connector (NC, GND, GND, +5), power
adapter connector (+5v, GND) and reserve power-on process
LED (Red/Green)
: -20°C ~ 70°C
: 5% ~ 95% RH, non-condensing
: 203 x 146 mm
: 350 g
: EN 50081-1/1994>EN 55022/1997>EN 61000-3-2/1995
>EN 61000-3-3/1995, EN 50082-1/1994>IEC 1000-4-2/1995,
IEC 1000-4-3/1995, IEC 1000-4-4/1995
: 4 layers PCB, one side SMT process
~2~

Advertisement

Table of Contents
loading

Table of Contents