Download Print this page

Lanner electronics MB-X71 Series Manual page 44

Socket 478 network security appliance control board ( 2xgbe, 4x10/100 lans )

Advertisement

AWARD BIOS SETUP
Reset Configuration Data : Normally, you leave this field "Disabled", Select "Enabled" to
reset Extended System Configuration Data (ESCD) when you exit Setup if you have
installed a new add-on and the system reconfiguration has caused such a serious conflict
that the operating system cannot boot.
The settings are : "Enabled and Disabled".
Resource Controlled By : The Award Plug and Play BIOS has the capacity to
automatically configure all of the boot and Plug and Play compatible devices. However,
this capability means absolutely nothing unless you are using a Plug and Play operating
system such as Windows98. If you set this field to "Manual" choose specific resources
by going into each of the sub menu that follows this field ( a sub menu is proceded by a
"
"). The settings are "Auto(ESCD)", "Manual".
IRQ Resources : When resources are controlled manually, assign each system interrupt
as one of the following types, depending on the type of device using the interrupt.
IRQs Resources:
IRQ3
assigned to
IRQ4
assigned to
IRQ5
assigned to
IRQ6
assigned to
IRQ7
assigned to
IRQ8
assigned to
IRQ9
assigned to
IRQ10
assigned to
IRQ11
assigned to
IRQ12
assigned to
IRQ13
assigned to
IRQ14
assigned to
IRQ15
assigned to
$ % & Move
Enter: Select +/-/PU/PD: Value F10: Save Esc: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults
IRQ3/4/5/7/9/10/11/14/15: These items specify the bus where the specified IRQ line is
used. The settings determine if AMIBIOS should remove an IRQ from the pool of available
IRQs passed to devices that are configurable by the system BIOS. The available IRQ pool
is determined by reading the ESCD NVRAM. If more IRQs must be removed from the IRQ
pool, the end user can use these settings to reserve the IRQ by assigning an ISA/EISA
setting to it. Onboard I/O is configures by AMIBIOS. All IRQs used by onboard I/O are
configured as PCI/PnP. If all IRQs are set to ISA/EISA, and IRQ14/15 are allocated to the
Legacy ISA
PCI/ISA PnP
PCI/ISA PnP
Legacy ISA
PCI/ISA PnP
PCI/ISA PnP
PCI/ISA PnP
PCI/ISA PnP
PCI/ISA PnP
PCI/ISA PnP
PCI/ISA PnP
PCI/ISA PnP
PCI/ISA PnP
~40~
Item Help
Menu Level ►►►
Legacy ISA for devices
compliant with the original
PC AT bus specification ,
PCI/ISA PnP for devices
compliant with the Plug and
Play standard whether
designed for PCI or ISA
bus architecture.
F7: Optimized Defaults

Advertisement

loading