Connecting Video And Audio; Plugging In Media - Blackmagicdesign HyperDeck Shuttle HD Installation And Operation Manual

Connecting Video and Audio

To connect video to your HyperDeck Shuttle HD, plug an HDMI video source into the HDMI
input on the rear panel.
Connect your destination equipment to the HDMI output. For example, an ATEM Mini switcher
or an HDMI television.
The HDMI output is also used to view the settings menu when changing settings for your
HyperDeck. This is because the settings menu is viewed via video overlay on the HDMI output.
More information about the menu settings can be found in the 'changing settings' section later
in this manual.
TIP If you cannot see your input video source on the connected display, you may be in
playback mode. Press the record button to enable record mode.
SD CARD
HDMI OUT
+12V DC ETHERNET EXT DISK HDMI IN
Plug the HDMI output into your destination equipment, such as an HDMI television or ATEM Mini switcher

Plugging in Media

All HyperDeck Shuttle HD disk recorders ship ready to record immediately without having to
configure any settings. All you need is a formatted SD card or external disk.
You can easily format media via the menu settings. You can also format using a computer.
Refer to the 'formatting media' section in this manual for more information. You can also
find information about the types of media that are best for recording video and a list of
recommended SD cards and external disks.
To plug in an SD card:
1 Hold the SD card with the gold connectors facing up and align it with the media slot. Now
gently push the card into the slot until you feel it lock firmly into place.
SD CARD
+ 12V DC
ETHERNET EXT DISK
HDMI
HDMI OUT
HDMI IN
Getting Started 6