Pro-Form PRO 9000 User Manual page 9

2. Make sure that the power cord is unplugged.
Locate the Upright Wire (90) attached to the
Base (96) with a tie. Remove the tie.
Next, identify the Right Upright (92). Have a
second person hold the Right Upright near the
Base (96).
See the inset drawing. Tie the wire tie (A) in
the Right Upright (92) securely around the end
of the Upright Wire (90). Then, insert the Upright
Wire into the lower end of the Right Upright, and
pull the upper end of the wire tie until the Upright
Wire is routed through the Right Upright.
3. Hold the Right Upright (92) against the Base
(96). Do not pinch the Upright Wire (90).
Attach the Right Upright (92) with two
3/8" x 2 3/8" Screws (3), a 3/8" x 1 1/4" Screw
(1), and three 3/8" Star Washers (9) as shown;
do not fully tighten the Screws yet.
Next, have a second person lift the right side of
the Frame (64) slightly while you attach a Wheel
(93) with a 3/8" x 1 3/4" Screw (4); do not fully
tighten the Screw yet.
Attach the Left Upright (not shown) and the
other Wheel (not shown) in the same way.
Note: There are no wires on the left side.
2
A
90
92
90
96
3
3
9
4
93
9
90
A
92
64
90
96
9
92
1