SFP Modules Setup Options Set up your Fortinet device locally. Installation Cage Socket MGMT Port Management Computer Ethernet Cable Note: For static IP configuration, use 192.168.1.100 with subnet mask 255.255.255.0 Removal Speed (default): 9600 Data bits: Cage Socket Stop bits:...
• A lifting device or additional support Lock Out Tab • ESD antistatic gear Support For video support on installing these slide rails, please visit: Outer Rails Inner Rails https://video.fortinet.com For additional support, please visit: Release Tab Locking Keyhole http://support.fortinet.com...
Page 6
Attach the Inner Rails to the Appliance Attach the Outer Rails to the Rack 1. Detach the inner rail from the rail assembly by pressing the lock out tab Front Outer Rail 2. Place an inner rail against a side of the appliance 1.
Page 7
FDD-2000F Front Power Button Ports 1 to 4 (SFP+) Blue: Device is on SFP+ Ports Green: Link established Off: Device is off LINK/ACT SPEED Flashing Green: Data activity LINK/ACT Off: No link established Status LED (STA) Device Reset (R) Factory Reset (F) (not in use) Green: System operating normally Blue: Connected at 10Gbps NMI Button (N) (not in use)
Page 8
FDD-2000F Rear 1 2 3 Power Switch Grounding Screws (12 AWG) Power Disarm Button Disables PSU warning tone Power Supplies Redundant, 100-240VAC, 10-5A, 50-60Hz Green: PSU providing device power Flashing Green: PSU providing standby power Amber: PSU not providing power, device is on Red: PSU failure detected Off: PSU is off...
Page 9
限用物質含有情況表 (RoHS Table) 請到以下 網址下載: socket outlet could place hazardous voltage on accessible metal parts. https://www.fortinet.com/bsmi Avertissement: Équipement de classe I. Cet équipement doit être mis à la terre. La fiche d’alimentation doit être connectée à une prise de terre correctement câblée.
Need help?
Do you have a question about the FortiDDoS 2000F and is the answer not in the manual?
Questions and answers