Chicco BI-SEAT i-Size Instruction Manual page 68

2. 76-105 cm >15 months (Max. 17.5 kg) "Intergral Universal ISO-
FIX "i-Size"" - installation with Full 360 i-Size base and Support
Leg forward-facing (see illustrations fro number 19 to 23)
FOCUS AREAS
a) Do not use the car seat without the base before 100 cm!
b) From 15 months / 76 cm the car seat can be installed forward-facing.
c) Installation must be carried out on seats equipped with the Isofix
System.
d) The child must not weigh more than 17.5 kg.
e) During installation with the Isofix system, the vehicle safety har-
ness must not be fastened behind the child car seat, as this would
engage the inflatable portion of the safety harness.
3. Changing the configuration from "i-SIZE" Universal integral
ISOFIX to "i-SIZE Booster Seat" (see illustrations from num-
ber 24 to 34)
4a. 100-150 cm i-SIZE Booster Seat: configuration with rigid
connectors and the car's three-point seat belt (see illustra-
tions from number 35 to 47)
FOCUS AREAS
a) The car seat must only be used without the base!
b) The vehicle seat must be equipped with a 3-point safety harness,
whether static or with a retractor, approved according to UN/ECE
Regulation no. 16 or other equivalent standards (Fig. 35).
c) The car seat can be installed on the front seat, passenger side, or on
any of the rear seats, and must always be positioned forward facing.
Never use this child car seat on vehicle seats facing the sides or op-
posite to the direction of the driver's seat (Fig. 37).
d) Never fit the child car seat to a vehicle seat that is only equipped
with a two-point safety belt (Fig. 36).
e) Make sure that the abdominal portion of the vehicle seat belt rests
correctly on the waist of the child.
f ) If used in a vehicle equipped with rear vehicle seat belts with inte-
grated air bags (inflatable seat belts), the interplay between the in-
flatable portion of the seat belt and this child restraint system could
cause serious injury or death. When using the car seat in vehicles
equipped with rear vehicle seat belts with integrated air bags (in-
flatable seat belts), follow the car manufacturer's instruction manual.
g) Make sure that the buckle of the car's three-point belt is not too
far up. Otherwise, try to install the car seat on a different seat in the
vehicle. In some cases the vehicle seat belt buckle may be too long
and may exceed the expected height above the bottom of the
car seat (Fig. 45A-45B). In this case the seat must not be fixed on
that seat but must be installed on another seat on which there is
no problem. For more information, contact your car manufacturer.
4b. 100-150 cm i-SIZE Booster Seat: installation with just the
car's 3-point safety belt (see illus-trations from 48 to 57)
FOCUS AREAS
a) The car seat must only be used without the base!
b) The vehicle seat must be equipped with a 3-point safety harness,
whether static or with a retractor, approved according to UN/ECE
Regulation no. 16 or other equivalent standards (Fig. 35).
c) The car seat can be installed on the front seat, passenger side, or on
any of the rear seats, and must always be positioned forward facing.
Never use this child car seat on vehicle seats facing the sides or op-
posite to the direction of the driver's seat (Fig. 37).
d) Never fit the child car seat to a vehicle seat that is only equipped
with a two-point safety belt (Fig. 36).
e) Make sure that the abdominal portion of the vehicle seat belt rests
68