Chevrolet Monte 2003 Owner's Manual page 109

FOB LIGHT (Remote Visual
Verification)
This feature allows the exterior lights to flash when the
remote keyless entry transmitter is used to lock or
unlock the vehicle, or to program no verification.
Programmable Modes
Mode 1: OFF
Mode 2: On – One flash for each remote
lock/two flashes for each remote unlock.
Your vehicle was originally programmed to Mode 2.
The mode may have been changed since then.
To determine the current mode, or to change the mode,
do the following:
1. Scroll, using the SEEK PSCAN up or down arrows,
until FOB LIGHT appears on the display.
2. Press the 1 PREV or 2 NEXT button to enter the
submenu. The current selection will have an
asterisk (*) next to it. If you do not wish to change
the current mode, you can either exit the
programming mode by following the directions later
in this section or program the next feature
available on your vehicle.
3. Scroll, using the 1 PREV or 2 NEXT buttons,
through the modes to change the current mode.
4. With your preference displayed, press the TUNE
DISP button to select. A chime will be heard to
verify the new setting. The new selection will
be displayed with an asterisk (*) for one second.
If your vehicle has the optional content theft-deterrent
system, the first time a remote UNLOCK command
is received, three flashes will be seen and three horn
chirps heard to indicate an alarm condition has occurred
since last arming. See Content Theft-Deterrent on
page 2-14 .
The mode you selected is now set. You can either exit
the programming mode by following the instructions
later in this section or program the next feature available
on your vehicle.
2-45