NordicTrack NTL15007.3 User Manual page 7

2. Identify the Left Upright (73) and the Right
Upright (74).
See the inset drawing. Have a second person
hold the Right Upright (74) near the Right Base
Cover (77). Tie the wire tie in the Right Upright
securely around the end of the Upright Wire
Harness (75). Pull the other end of the wire tie
up through the rectangular hole in the bottom of
the Right Upright until the Upright Wire Harness
is routed completely through the Right Upright.
Gently pull up on the Upright Wire Harness (75)
as you set the Right Upright (74) on the Base
(83) inside the Right Base Cover (77). Be care-
ful not to pinch the Upright Wire Harness.
Partially attach the Right Upright (74) to the
Base (83) with two Upright Bolts (72) and two
Upright Star Washers (90). Do not tighten the
Upright Bolts yet. Note: It may be necessary to
tip the tops of the Uprights forward slightly as
you thread the Upright Bolts into the Uprights.
Attach the Left Upright (73) to the Base (83) with
two Upright Bolts and two Upright Star Washers
(not shown). Do not tighten the Upright Bolts
yet.
With the help of a second person, lower the
treadmill off the cardboard stand.
3. Identify the Right Upright Sleeve (96) and the
Left Upright Sleeve (95), which are labeled.
Slide the Right Upright Sleeve onto the Right
Upright (74). Slide the Left Upright Sleeve onto
the Left Upright (73).
2
Wire
Tie
73
3
73
7
74
75
Wire Tie
75
74
77
95
"Left"
"Right"
74
83
90
72
96