Changing The Battery - Boss OD-3 Owner's Manual

CHANGING THE BATTERY

When the indicator goes dim or no longer
lights while an effect is on, it means that the
battery is nearly dead and must be re-
placed.
Replace the battery following the steps
below.
Battery Snap Cord
Battery Snap
9V Battery
12
1 Loosen the thumbscrew at the front of
2 Remove the old battery from the battery
Thumbscrew
Pedal
Spring Base
3 Connect the snap cord to the new bat-
Coil Spring
4 Slip the coil spring onto the spring base
Guide
Bush
Hole
Battery
Housing
5 Finally, insert the thumbscrew into the
the pedal, then lift the pedal upwards to
open the unit.
* The thumbscrew can be left in the pedal
while changing the battery.
housing, and remove the snap cord con-
nected to it.
tery, and place the battery inside the
battery housing.
* Be sure to carefully observe the battery's
polarity (+ versus -).
on the back of the pedal, then close the
pedal.
* Carefully avoid getting the snap cord
caught in the coil spring.
guide bush hole and fasten it securely.