Milwaukee MW14 User Manual

SPECIFICATIONS

Range 0.00 to 5.00 ppm
Resolution 0.01 ppm
±0.04 ppm ±2% of reading
Accuracy
@ 25 °C
Typical EMC Dev. ±0.01 ppm
Light Emitting Diode
Light Source
@ 525 nm
Light Detector Silicon Photocell
Adaptation of the EPA
Phenantroline method
315B, for natural and treated
Method
waters. The reaction between
iron and reagent causes an
orange tint in the sample.
0 to 50°C (32 to 122 °F)
Environment
max. 95% RH non-condensing
Battery Type 1 x 1.5V AAA
After 10 minutes of non-use
Auto-Shut O
and 2 minutes after reading
87.5 x 63.7 x 35.2 mm
Dimensions
(3.4 x 2.5 x 1.4")
Weight 65 g (2.29 oz.)

OPTIONAL ACCESSORIES

Reagent Sets
MI528-25 Iron powder reagent (25 pcs.)
Other Accessories
MI0011 Glass cuvettes (2 pcs.)
MI0013 Stoppers for cuvettes (2 pcs.)

CERTIFICATION

Milwaukee Instruments conform to the
CE European Directives.
Disposal of Electrical & Electronic
Equipment. Do not treat this product
as household waste. Hand it over to
the appropriate collection point for the
recycling of electrical and electronic
equipment.
Disposal of waste batteries. This product
contains batteries. Do not dispose of them with
other household waste. Hand them over to the
appropriate collection point for recycling.
Please note: proper product and battery disposal
prevents potential negative
for human health and the environment. For
detailed information, contact
household waste disposal service or go to
www.milwaukeeinstruments.com (USA & CAN)
or www.milwaukeeinstruments.eu.

RECOMMENDATION

Before using this product, make sure it is entirely
suitable for your specific application and for the
environment in which it is used. Any modification
introduced by the user to the supplied equipment
may compromise the tester's performance. For
your and the tester's safety do not use or store
the tester in hazardous environment. To avoid
damage or burn, do not perform any measurement
in microwave ovens.

WARRANTY

This tester is warranted against defects in
materials and manufacturing for a period of
2 years from the date of purchase. This warranty
is limited to repair or free of charge replacement
if the tester cannot be repaired. Damage due to
accidents, misuse, tampering or lack of prescribed
maintenance is not covered by warranty. If
service is required, contact your local Milwaukee
Instruments Technical Service. If the repair is not
covered by the warranty, you will be notified of
the charges incurred. When shipping any tester,
make sure it is properly packaged for complete
protection.
Milwaukee Instruments reserves the right to
make improvements in design, construction and
appearance of its products without advance notice.
ISTMW14 04/21
USER MANUAL
consequences
your local
Pacific Sensor Technologies Pty Ltd
Unit 4, 3 Neutron Place Rowville, VIC 3178 Australia
1300 662 720 | sales@pacificsensortech.com.au
SATISFACTION
GUARANTEED
MW14 Digital
Iron Tester
ppm
1. 5 4
Iron
MW14
Distributor in Australia
www.pacificsensortech.com.au