Table of Contents
Advertisement
Table 26. System Configuration (continued)
Option
Smart Reporting
USB Configuration
Audio
Miscellaneous Devices
Video
Option
Description
LCD Brightness
Allows you to set the display brightness depending up on the power source—On Battery and On AC. The
LCD brightness is independent for battery and AC adapter. It can be set using the slider.
NOTE:
The video setting is visible only when a video card is installed into the system.
Security
Table 27. Security
Option
Admin Password
System Password
Strong Password
Password Configuration
Password Bypass
Password Change
Non-Admin Setup Changes
20
System setup
Description
This field controls whether hard drive errors for integrated drives are reported during system
startup. The Enable Smart Reporting option is disabled by default.
Allows you to enable or disable the integrated USB controller for:
● Enable USB Boot Support
● Enable External USB Port
All the options are enabled by default.
Allows you to enable or disable the integrated audio controller. The option Enable Audio is
selected by default.
● Enable Microphone
● Enable Internal Speaker
Both the options are selected by default.
Allows you to enable or disable the following devices:
● Enable Camera (enabled by default)
Description
Allows you to set, change, and delete the admin password.
Allows you to set, change, and delete the system password.
This option lets you enable or disable strong passwords for the system.
Allows you to control the minimum and maximum number of characters allowed for a
administrative password and the system password. The range of characters is between 4
and 32.
This option lets you bypass the System (Boot) Password and the internal HDD password
prompts during a system restart.
● Disabled — Always prompt for the system and internal HDD password when they are set.
This option is enabled by default.
● Reboot Bypass — Bypass the password prompts on Restarts (warm boots).
NOTE:
The system will always prompt for the system and internal HDD passwords when
powered on from the off state (a cold boot). Also, the system will always prompt for
passwords on any module bay HDDs that may be present.
This option lets you determine whether changes to the System and Hard Disk passwords are
permitted when an administrator password is set.
Allow Non-Admin Password Changes - This option is enabled by default.
Determines whether changes to the setup option are permitted when an administrator
password is set.
Advertisement
Table of Contents
